EasyManua.ls Logo

Cisco Catalyst 2960-CX

Cisco Catalyst 2960-CX
88 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Catalyst 3560-CX and 2960-CX Switch Hardware Installation Guide
First Published: February 05, 2015
Last Modified: June 24, 2015
Americas Headquarters
Cisco Systems, Inc.
170 West Tasman Drive
San Jose, CA 95134-1706
USA
http://www.cisco.com
Tel: 408 526-4000
800 553-NETS (6387)
Fax: 408 527-0883

Table of Contents

Other manuals for Cisco Catalyst 2960-CX

Questions and Answers:

Cisco Catalyst 2960-CX Specifications

General IconGeneral
PoENo
DRAM512 MB
MAC Address Table Size16, 000 entries
StackingNo
ModelCisco Catalyst 2960-CX
Ports8 x 10/100/1000 Ethernet ports
Uplink Interfaces2 x 1G SFP
Power Input100 to 240 VAC
Operating Temperature0°C to 40°C (32°F to 104°F)
Storage Temperature-25°C to 70°C (-13°F to 158°F)
Power Consumption15W
Relative Humidity10 to 95% noncondensing

Summary

Product Overview

Switch Models

Describes various Catalyst 3560-CX and 2960-CX switch models and their features.

Front Panel

Details the components and ports located on the front of the switch.

PoE and PoE+ Ports

Explains Power over Ethernet (PoE) and PoE+ port capabilities and specifications for connected devices.

Management Options

Outlines different methods for managing and configuring the switch, including Cisco Network Assistant and CLI.

Switch Installation

Warnings

Provides essential safety warnings and precautions to be observed before and during switch installation.

Mounting the Switch

Provides instructions for mounting the switch in various configurations, including on a desk, shelf, wall, or rack.

Troubleshooting

Diagnosing Problems

Explains how to use switch LEDs and other tools to diagnose operational issues.

Resetting the Switch

Provides instructions on how to reboot or reset the switch to troubleshoot issues.

Technical Specifications

Power Requirements

Outlines the electrical requirements, including AC input voltage and power consumption ratings.

PoE Power Consumption

Details the power consumption characteristics of the switch with and without PoE enabled.

Configuring the Switch with the CLI-Based Setup Program

Accessing the CLI Through Express Setup

Guides on accessing the switch's Command Line Interface (CLI) via Express Setup mode.

Accessing the CLI Through the Console Port

Explains how to access the CLI using the RJ-45 console port or USB console port.

Entering the Initial Configuration Information

Details the information required and steps to perform the initial switch configuration.

Completing the Setup Program

Covers the final steps of the setup program, including saving the configuration and setting basic parameters.

Related product manuals