Cisco Catalyst 2960-CX User Manual

Internal Power Supply
All the switches except Catalyst 3560CX-8PT-S are powered through their internal power supplies. The
internal power supply is an autoranging unit that supports input voltages between 100 and 240 VAC. Plug
the AC power cord into the AC power connector and into an AC power outlet.
Security Slot
The switches have security slots on the rear panel. You can install an optional cable lock, such as the type
that is used to secure a laptop computer, to secure the switch.
Figure 7: Switch Rear Panel
For PoE models, the security slot is on the right side of the rear panel.Note
Auxiliary Power Adapter
Catalyst 3560CX-8PT-S switches can be powered either through the 10/100/1000 uplink ports receiving power
from a PoE, PoE+ or UPOE switch or through an auxiliary AC-DC or DC-DC power adapter. You can order
Catalyst 3560-CX and 2960-CX Switch Hardware Installation Guide
10
Product Overview
Internal Power Supply

Cisco Catalyst 2960-CX Specifications

General

PoE	No
DRAM	512 MB
MAC Address Table Size	16, 000 entries
Stacking	No
Model	Cisco Catalyst 2960-CX
Ports	8 x 10/100/1000 Ethernet ports
Uplink Interfaces	2 x 1G SFP
Power Input	100 to 240 VAC
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-25°C to 70°C (-13°F to 158°F)
Power Consumption	15W
Relative Humidity	10 to 95% noncondensing