Cisco Catalyst 2960-CX User Manual

Step 4
Insert the screws in the holes on the mounting tray or DIN rail mount, and tighten them.
Figure 29: Attaching the power adapter to the switch
Installing the Power Cord Retainer (Optional)
This section applies to switches with an AC power connector.Note
The power cord retainer part number (PWR-CLP=) is optional. You can order it when you order your switch,
or you can order it later from your Cisco representative.
Step 1
Choose the sleeve size of the power cord retainer based on the thickness of the cord. The smaller sleeve can be snapped
off and used for thin cords.
Catalyst 3560-CX and 2960-CX Switch Hardware Installation Guide
36
Switch Installation
Installing the Power Cord Retainer (Optional)

Cisco Catalyst 2960-CX Specifications

General

PoE	No
DRAM	512 MB
MAC Address Table Size	16, 000 entries
Stacking	No
Model	Cisco Catalyst 2960-CX
Ports	8 x 10/100/1000 Ethernet ports
Uplink Interfaces	2 x 1G SFP
Power Input	100 to 240 VAC
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-25°C to 70°C (-13°F to 158°F)
Power Consumption	15W
Relative Humidity	10 to 95% noncondensing