2-18
Catalyst 3750-X and 3560-X Switch Hardware Installation Guide
OL-19593-01
Chapter 2 Switch Installation
Installing the Switch
Mounting the Switch in a Rack
After the brackets are attached to the switch, use the supplied Phillips machine screws to attach the
brackets to the rack (
Figure 2-19). Use the black Phillips machine screw to attach the cable guide to the
left or right bracket.
When you complete the switch installation, see the “After Installing the Switch” section on page 2-21
for more information switch configuration.
1 Front-mounting position 4 Rear-mounting position
2 Number-8 Phillips flat-head screws 5 Four-point mounting positions
3 Mid-mounting position
To Next Page
Loading...
