Cisco Catalyst 3560X-24T - Stackpower Partitioning Examples; Installing the Switch; Rack-Mounting

2-14
Catalyst 3750-X and 3560-X Switch Hardware Installation Guide
OL-19593-01
Chapter 2 Switch Installation
Installing the Switch
StackPower Partitioning Examples
Figure 2-15 and Figure 2-16 show StackPower stacks of Catalyst 3750-X switches with failover
conditions. In Figure 2-15, the StackPower cable 2 is faulty. Therefore, this stack does not provide
redundancy.
Figure 2-15 Example of a StackPower Stack with a Failover Condition
In Figure 2-16, StackPower port B on the center switch has failed and this stack partitions into two
stacks. The top two switches share power, and the bottom switch is now a separate stack.
Figure 2-16 Example of a Partitioned StackPower Stack with a Failover Condition
Installing the Switch
• Rack-Mounting, page 2-14
• Table- or Shelf-Mounting, page 2-20
• After Installing the Switch, page 2-21
The illustrations shown in this section show the Catalyst 3750-X-48 PoE switch as an example. You can
install the Catalyst
3750-X and 3560-X switches following the same procedures.
Rack-Mounting
To install the switch in a 19-inch rack, follow the instructions described in this section.
STACK 1 STACK 2
STACK 1 STACK 2
STACK 1 STACK 2
253401
1
2
3
STACK 1 STACK 2
STACK 1 STACK 2
STACK 1 STACK 2
253402
1
2