EasyManuals Logo

Cisco CBS350-24P-4G Get To Know

Cisco CBS350-24P-4G
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
Step 7 Remove the screw template from the wall.
Step 8 Place the switch onto the mounting screws, and slide it down until it locks in place.Wall-mounting an 8-port switch
Figure 4 Wall-mounting an 8-port switch
Out-Of-Band Port
The switch supports an Out-of-Band (OOB) port which is used for the management network. The out-of-band
and the in-band ports share the same IP routing table. Thus, the same subnet can not be used on both the
in-band and out-of-band interfaces.
The OOB port is assigned an MAC address which differs from the base MAC address and the in-band ports
addresses. This MAC address is used as the source MAC address in all frames sent by the switch on the OOB
Get To Know Your Switch
5
Get To Know Your Switch
Out-Of-Band Port

Other manuals for Cisco CBS350-24P-4G

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco CBS350-24P-4G and is the answer not in the manual?

Cisco CBS350-24P-4G Specifications

General IconGeneral
ModelCBS350-24P-4G
CategorySwitch
Ports24 x 10/100/1000 PoE+ ports
PoE Budget195W
Switching Capacity56 Gbps
Power SupplyInternal
MAC Address Table Size16K
Jumbo Frame Support9KB
Memory256 MB
Operating Temperature0°C to 45°C
Operating Humidity10% to 90% non-condensing
Uplink Ports4 x 1G SFP
ManagementManaged

Related product manuals