Cisco CRS - Page 31

Step 5
Attach the inner cut-out plates, as shown in the figure below, using the four screws provided. See the figure Inner Cut-out
Plate—Fixed Configuration Power Shown.
Figure 20: Cut-out plate
Figure 21: Inner Cut-out Plate — Fixed Configuration Power Shown
Step 6
Attach the outer cut-out panel using the screws provided. See the figure below.
Figure 22: Outer cut-out plate — Fixed Configuration Power Shown
Cisco CRS Carrier Routing System Fabric Card Chassis Installation Guide
31
Installing and Removing Exterior Cosmetic Components
Steps