Cisco CRS - Page 33

Step 7
Attach the rear upper horizontal cable guides (see the figure below) by inserting five longer Phillips screws through the
holes in the face of the brackets and into the chassis and tightening them to the chassis with the screwdriver.
Figure 23: Attaching the Rear Upper Horizontal Cable Guide
6 mm long screw attaching cable guide to chassis (quantity=
5)
1
4-mm long screw attaching cable guide to vertical trough
(quantity=4)
2
Step 8
Insert the four short Phillips screws (two on each side) that attach the bracket to the vertical cable trough support flange
and tighten them to the troughs with the screwdriver.
Step 9
Attach the rear mid-chassis horizontal cable guide and strike tube (see the figure below) by inserting the five longer
Phillips screws through the holes in the face of the brackets and into the rear (OIM) side of the chassis and tightening
them to the chassis with the screwdriver.
Cisco CRS Carrier Routing System Fabric Card Chassis Installation Guide
33
Installing and Removing Exterior Cosmetic Components
Steps