7 Wait a few seconds for the device to be discovered. When discovered, an LED
labeled MoCA should turn on. At this point, a MoCA node should be active in
the network.
8 If you have not already done so, connect an Ethernet compatible device (for
example, a set-top, computer, or PlayStation) to the Ethernet port on the
residential gateway. The ONLINE LED should turn on and the device should be
ready to use.
9 Follow the steps above to connect additional residential gateways to the
network; note that up 15 residential gateways can be added to a MoCA network.
10 From the user interface, you can monitor a limited number of parameters
associated with the MoCA network. You may login at any time to check for
status or for troubleshooting purposes.
To Next Page
Loading...
