Chapter 2 Installing the Residential Gateway
The Residential Gateway will perform an automatic search to locate and sign on
to the broadband data network. This process may take up to 2-5 minutes. The
Residential Gateway will be ready for use when the P owe r , US/DS, and Online
LEDs on the front panel of the residential gateway stop blinking and remain on
continuously.
7 Wait a few seconds for the device to de discovered. When discovered, an LED
labeled 2.4 GHz or 5 GHz should turn on. At this point, a MoCA node should be
active in the network.
8 If you have not already done so, connect an Ethernet compatible device (for
example, a set-top, computer, or PlayStation) to the Ethernet port on the
Residential Gateway. The ONLINE LED should turn on and the device should
be ready to use.
9 Follow the steps above to connect additional Residential Gateways to the
network; note that up 15 residential gateways can be added to a MoCA network.
10 From the user interface, you can monitor a limited number of parameters
associated with the MoCA network. You may login at any time to check for
status or for troubleshooting purposes.
To Next Page
Loading...
