Use the descriptions and instructions in the following table to manually set up and
connect WPS clients, WPS PIN method and Push Button. After you make your
selections, click Pair to connect your wireless device.
Field Description
SSID
Click the SSID drop-down arrow to select the SSID to connect
a client to using WPS.
WiFi Protected
Setup (WPS)
Enable - Click to make the WPS mechanism active.
Disable - Click to make the WPS mechanism inactive.
WPS PIN Method
Enable - Click to make the WPS PIN Method active.
Disable - Click to make the WPS PIN Method inactive.
Connection Options
Click the Connection Options drop-down arrow to select the
connection method to use. When selecting the Push Button
method, click PAIR after the client has asked the WPS button
be pushed. The wireless device will connect within two
minutes.
Wireless Clients PIN
To pair, select the Pair button and your wireless device will
connect within two minutes. You may also press the [push]
button on this device. The Wireless Clients PIN, found from
client, needs to be entered in this field and click PAIR.
To Next Page
Loading...
Need help?
General