Cisco EPC3925 - Page 101

4021192 Rev B
Front Panel LED Status Indicator Functions
Normal Operations (AC Power applied)
The following chart illustrates the appearance of the residential gateway front panel
LED status indicators during normal operations when AC power is applied to the
gateway.
Front Panel LED Status Indicators During Normal Conditions
Front Panel Indicator
Normal Operations
1
POWER
On
2
DS
On
3
US
On
4
ONLINE
On
5
ETHERNET
1 - 4
 On - When a single device is connected to the Ethernet port and no data is being sent
to or from the modem
 Blinks - When only one Ethernet device is connected and data is being transferred
between the consumer premise equipment (CPE) and the wireless home gateway
 Off - When no devices are connected to the Ethernet ports
6
USB
 On - When a single device is connected to the USB port and no data is being sent to or
from the modem
 Blinks - When only one USB device is connected and data is being transferred between
the consumer premise equipment (CPE) and the wireless home gateway
 Off - When no devices are connected to the USB ports
7
WIRELESS
LINK
 On - When the wireless access point is enabled and operational
 Blinks - When data is being transferred between the CPE and the wireless home
gateway
 Off - When the wireless access point is disabled by the user
8
WIRELESS
SETUP
 Off - When wireless setup is not active
 Blinks - When wireless setup is active to add new wireless clients on the wireless
network
9
TEL 1
 On - When telephony service is enabled
 Blinks - When line 1 is in use
10
TEL 2
 On - When telephony service is enabled
 Blinks - When line 2 is in use