Cisco Firepower 1010 Series User Manual

DescriptionPID
Cisco Firepower 1010 and 1010E 150-W power
supply (spare)
FPR1K-DT-PWR-AC=
Cisco Firepower 1010 and 1010E rack-mount kit
(spare)
FPR1K-DT-RACK-MNT=
Cisco Firepower 1010 and 1010E wall-mount kit
(spare)
FPR1K-DT-WALL-MNT=
Cisco Firepower 1010 FIPS kit (spare)FPR1K-DT-FIPS-KIT=
Power Cord Specifications
Each power supply has a separate power cord. Standard power cords or jumper power cords are available for
connection to the security appliance. The jumper power cords for use in racks are available as an optional
alternative to the standard power cords.
If you do not order the optional power cord with the system, you are responsible for selecting the appropriate
power cord for the product. Using a incompatible power cord with this product may result in electrical safety
hazard. Orders delivered to Argentina, Brazil, and Japan must have the appropriate power cord ordered with
the system.
Only the approved power cords or jumper power cords provided with the chassis are supported.
Note
The following power cords are supported.
Figure 10: Argentina (CAB-AC-C5-ARG)
Cord set rating: 2.5 A, 250 V2Plug: IRAM 20731
—Connector: IEC 60320/C53
Cisco Firepower 1010 Series Hardware Installation Guide
16
Overview
Power Cord Specifications

Cisco Firepower 1010 Series Specifications

General

Brand	Cisco
Model	Firepower 1010 Series
Category	Network Hardware
Language	English