To Next PageTo Next Page
Need help?Do you have a question about the Cisco Catalyst 8300 Series and is the answer not in the manual?
General| Software | Cisco IOS XE |
|---|---|
| Interface Modules | Modular |
| WAN Ports | Varies based on module selection |
| LAN Ports | Varies based on module selection |
| Redundancy | Yes, with dual power supplies and modular components |
| Security | Integrated threat defense, encryption, and secure boot |
| Management | Cisco DNA Center, CLI, SNMP, REST APIs |
| Form Factor | Rack-mountable |
| Rack Height | 1RU or 2RU |
| Interfaces | Gigabit Ethernet, 10 Gigabit Ethernet, 25 Gigabit Ethernet, 40 Gigabit Ethernet, 100 Gigabit Ethernet, Serial |
| Power Supply | Redundant power supply options available |
| Key Features | SD-WAN, advanced security |
| Product Family | Catalyst |
| Port Density | Varies based on module selection |
| Dimensions | Varies by model |
| Weight | Varies by model and module selection |
Illustrates power supply and I/O sides of Cisco Catalyst 8300 Series Edge Platforms.
Describes the hardware capabilities including interface ports and modules.
Details the variety of field-replaceable and externally accessible power supply configurations.
Defines warning conventions and lists core safety warnings grouped by topic.
Specifies environmental conditions for safe router installation and operation.
Provides guidelines for planning equipment rack configuration and clearances.
Details site power checks and requirements for clean power reception.
Instructions for installing Network Interface Modules, Service Modules, and Field-Replaceable Units.
Steps for securely mounting the chassis into an equipment rack.
Procedure for connecting the chassis to a reliable earth ground for safety.
Explains how to connect the device to the power source, including AC and DC connections.
Critical safety precautions before accessing or replacing internal hardware.
Detailed steps for safely removing and reinstalling the device chassis cover.
Procedure for removing and installing AC and DC power supply units.
Instructions for installing and removing Small Form-factor Pluggable modules.
Introduces Network Interface Modules (NIMs) and their supported features.
Step-by-step guide for removing and installing NIMs.
Covers safety warnings, maintenance guidelines, and recommendations for service modules.
Procedure for installing a service module into the device.
Instructions on how to install a Pluggable Interface Module (PIM) into the device.
Steps for inserting and configuring antennas on a 5G Pluggable Interface Module.
Explains the Online Insertion and Removal (OIR) process for modules.
Steps to remove a module using OIR commands and console prompts.
