Cisco Catalyst 8300 Series User Manual

DescriptionColorLED
Environmental Status
Off: Monitor is not active.
Red: The system has detected a
critical overcurrent event and may
shut down.
Blinking Yellow: One or more
temperature sensors in the system
are outside the acceptable range.
Yellow: One or more fans in the
system are outside the acceptable
range.
Green: All temperature sensors and
fans in the system are within
acceptable range.
Green/Amber/RedENV
USB Console Active
Green indicates that the active
console port is USB.
GreenUSB CON
Serial Console Active
Green indicates that RJ-45 is the
active console port.
Green/YellowRJ-45 CON
SFP Enable LED
SFP+ Enable LED
Off: Not present
Green: The SFP is supported and
no faults.
Amber: The SFP is not supported
or is in a faulty state
GreenSFP EN
SFP port 0/1 Link LED
Off: No Link (or not present)
Green: Link established
GreenSFP LINK
Fans, Ventilation, and Airflow
Chassis Ventilation
The chassis temperature is regulated with internal fans. An onboard temperature sensor controls the fan speed.
The fans are always on when the device is powered on. Under all conditions, the fans operate at the slowest
Hardware Installation Guide for Cisco Catalyst 8300 Series Edge Platforms
12
Overview
Fans, Ventilation, and Airflow

Cisco Catalyst 8300 Series Specifications

General

Software	Cisco IOS XE
Interface Modules	Modular
WAN Ports	Varies based on module selection
LAN Ports	Varies based on module selection
Redundancy	Yes, with dual power supplies and modular components
Security	Integrated threat defense, encryption, and secure boot
Management	Cisco DNA Center, CLI, SNMP, REST APIs
Form Factor	Rack-mountable
Rack Height	1RU or 2RU
Interfaces	Gigabit Ethernet, 10 Gigabit Ethernet, 25 Gigabit Ethernet, 40 Gigabit Ethernet, 100 Gigabit Ethernet, Serial
Power Supply	Redundant power supply options available
Key Features	SD-WAN, advanced security
Product Family	Catalyst
Port Density	Varies based on module selection
Dimensions	Varies by model
Weight	Varies by model and module selection