Cisco Catalyst 8300 Series User Manual

Figure 69: USB Memory Stick
You can insert or remove the memory stick whether the device is powered on or not.
Note
USB Type C (3.0) (USB 1)1
USB stick2
USB Type A (3.0) (USB 0)3
What to do next
This completes the USB Flash memory installation procedure.
Remove and Install an M.2 USB|NVMe Module
This section describes installing and replacing an M.2 USB|NVMe module on the Cisco Catalyst 8300 Series
Edge Platforms.
Prevent Electrostatic Discharge Damage
The M.2 module is sensitive to electrostatic discharge (ESD) damage, which can occur when electronic cards
or components are handled improperly. ESD results in complete or intermittent failures.
To prevent ESD damage, follow these guidelines:
• Always use an ESD wrist or ankle strap and ensure that it makes good skin contact.
Hardware Installation Guide for Cisco Catalyst 8300 Series Edge Platforms
93
Install Internal Components and Field Replaceable Units
Remove and Install an M.2 USB|NVMe Module

Cisco Catalyst 8300 Series Specifications

General

Software	Cisco IOS XE
Interface Modules	Modular
WAN Ports	Varies based on module selection
LAN Ports	Varies based on module selection
Redundancy	Yes, with dual power supplies and modular components
Security	Integrated threat defense, encryption, and secure boot
Management	Cisco DNA Center, CLI, SNMP, REST APIs
Form Factor	Rack-mountable
Rack Height	1RU or 2RU
Interfaces	Gigabit Ethernet, 10 Gigabit Ethernet, 25 Gigabit Ethernet, 40 Gigabit Ethernet, 100 Gigabit Ethernet, Serial
Power Supply	Redundant power supply options available
Key Features	SD-WAN, advanced security
Product Family	Catalyst
Port Density	Varies based on module selection
Dimensions	Varies by model
Weight	Varies by model and module selection