Need help?Do you have a question about the Cisco Codec Pro and is the answer not in the manual?
General| Power | 100-240V AC, 50/60 Hz |
|---|---|
| Video Standards | H.264, H.265 |
| Frame Rate | Up to 60 fps |
| Video Output | 2 x HDMI output |
| Audio Input | HDMI, USB |
| Audio Output | HDMI |
| Network | 1x Ethernet (RJ-45), 10/100/1000 Mbps |
| Control | Ethernet |
| Audio Standards | AAC, Opus |
| Maximum Resolution | 4K Ultra HD (3840 x 2160) |
| Operating Temperature | 0°C to 40°C |
| Storage Temperature | -20°C to 60°C |
| Humidity | 10% to 90% RH |
Lists antennas included for the radio version of the Codec Pro.
Details the power cable provided with the Codec Pro.
Describes optional rack mounting accessories for the Codec Pro.
Installation guide for Codec Pro with SpeakerTrack 60 camera.
Installation guide for Codec Pro with Quad Camera.
Installation guide for Codec Pro with Precision 60 camera.
Installation guide for Codec Pro with PTZ 12 camera.
Installation guide for Codec Pro with PTZ 4K camera.
Describes wall/ceiling mounting brackets and Cisco table/ceiling microphones.
Recommends Cisco HDMI and Ethernet cables, specifying types.
Instructions to always use the provided power cable and adapter (12VDC, 5A min).
Reference to the Administrator Guide for further codec setup details.
Details antenna, audio line, microphone, GPIO, COM, and ground connections on the rear panel.
Details main power input, HDMI outputs, camera inputs, and Ethernet network ports.
Details HDMI inputs, SDI camera input, USB, and Ethernet network ports.
Covers maintenance, factory reset, camera control, PoE, touch panel, LED, and power switch.
Identifies and details ports on the SpeakerTrack 60 camera connector panel.
Identifies and details ports on the SpeakerTrack 60 unit connector panel.
To Next Page