Installation Overview
• Performing a Preinstallation Configuration (Optional), on page 1
• Preinstallation Checks and Installation Guidelines, on page 3
• Mounting the Access Point, on page 4
• Installing a Lightning Arrestor, on page 15
• Grounding the Access Point, on page 17
• Powering the Access Point, on page 19
• Connecting Data Cables, on page 21
Performing a Preinstallation Configuration (Optional)
The following procedures describe the processes to ensure that your AP installation and initial operation go
as expected.
Performing a preinstallation configuration is an optional procedure. If your network controller is properly
configured, you can install your AP in its final location and connect it to the network from there.
Note
The following illustration shows the preinstallation configuration setup:
Installation Overview
1
To Next Page
Need help?
General
