EasyManuals Logo

Cisco Catalyst 8300 Series User Manual

Cisco Catalyst 8300 Series
126 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #111 background imageLoading...
Page #111 background image
CHAPTER 6
Install Cisco Catalyst Service Module
This section describes how to install the Cisco Catalyst Service Modules on the Cisco Catalyst 8300 Series
Edge Platforms. The service modules supported on the on the Cisco Catalyst 8300 Series Edge Platforms are:
C-SM-16P4M2X
C-SM-40P8M2X
For additional information on the supported SMs, see the Cisco Catalyst 8300 Series Edge Platforms' datasheet
on cisco.com.
Only one service module is supported within a single chassis at a time
Reload the system when you need to switch between the switching modes
You can perform online insertion and removal of the modules. After installing the service module,
you must reload the system to enable and activate the next-generation switching feature set.
Note
Prepare for Installation, on page 103
Equipment That You Need, on page 103
Remove the Cisco Catalyst Service Module, on page 104
Install a Cisco Catalyst Service Module, on page 104
Prepare for Installation
The following sections describe safety warnings, general maintenance guidelines, and safety recommendations
that you must read before installing and using the service module:
Equipment That You Need
Ratcheting torque screwdriver with a number-2 Phillips head that exerts a maximum of 15 pound-force
inches (lbf-in.) of pressure
Wire-stripping tools
Hardware Installation Guide for Cisco Catalyst 8300 Series Edge Platforms
103

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 8300 Series and is the answer not in the manual?

Cisco Catalyst 8300 Series Specifications

General IconGeneral
SoftwareCisco IOS XE
Interface ModulesModular
WAN PortsVaries based on module selection
LAN PortsVaries based on module selection
RedundancyYes, with dual power supplies and modular components
SecurityIntegrated threat defense, encryption, and secure boot
ManagementCisco DNA Center, CLI, SNMP, REST APIs
Form FactorRack-mountable
Rack Height1RU or 2RU
InterfacesGigabit Ethernet, 10 Gigabit Ethernet, 25 Gigabit Ethernet, 40 Gigabit Ethernet, 100 Gigabit Ethernet, Serial
Power SupplyRedundant power supply options available
Key FeaturesSD-WAN, advanced security
Product FamilyCatalyst
Port DensityVaries based on module selection
DimensionsVaries by model
WeightVaries by model and module selection

Related product manuals