Cisco Firepower 1010 Installation, Maintenance, And Upgrade

Installation, Maintenance, and Upgrade
• Install the FIPS Opacity Shield , on page 1
Install the FIPS Opacity Shield
Because the FIPS opacity shield covers the serial number on the chassis, the CO should copy the serial number
and store it in a secure place. The serial number is needed when you call Cisco TAC. See Serial Number
Location for the location of the serial number.
Note
You can only install the FIPS opacity shield with the desktop mount or wall mount. The rack mount does not
support the FIPS shield. See Desktop-Mount the Chassis and Wall-Mount the Chassis for more information.
Note
Before you begin
This procedure should be performed only by the Crypto Officer (CO).
Caution
You need the following to install the FIPS opacity shield:
• #1 Phillips head screwdriver
• The following items from the FIPS kit (part number 69-100649-01):
• One FIPS opacity shield (part number 800-106088-01)
• Three M3 x 66 mm (part number 48-0384-01) screws used to attach the FIPS opacity shield to the
chassis
• Nine Tamper Evidence Labels (TELs) (part number 47-25553-01)
Installation, Maintenance, and Upgrade
1

Cisco Firepower 1010 Specifications

General

Brand	Cisco
Model	Firepower 1010
Category	Firewall
Language	English