EasyManuals Logo

Cisco Firepower 1120 Getting Started

Cisco Firepower 1120
42 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #27 background imageLoading...
Page #27 background image
Can be changed during initial
configuration?DefaultSetting
No.
For Firepower 4100/9300: Yes.
The data interfaces on the device. Typically
the outside interface becomes the route to
the Internet. This gateway works for
from-the-device traffic only. If the device
receives a default gateway from the DHCP
server, then that gateway is used.
Firepower 4100/9300: Set the gateway IP
address when you deploy the logical device.
ISA 3000: 192.168.45.1.
FTDv: 192.168.45.1
Management gateway.
YesThe OpenDNS public DNS servers, IPv4:
208.67.220.220 and 208.67.222.222; IPv6:
2620:119:35::35. DNS servers obtained
from DHCP are never used.
Firepower 4100/9300: Set the DNS servers
when you deploy the logical device.
DNS servers for the management interface.
No.192.168.95.1/24
Firepower 4100/9300: Data interfaces are
not pre-configured.
ISA 3000: BVI1 IP address is not
preconfigured. BVI1 includes all inside and
outside interfaces.
FTDv: 192.168.45.1/24
Inside interface IP address.
No.Running on the inside interface with the
address pool 192.168.95.5 -
192.168.95.254.
Firepower 4100/9300: No DHCP server
enabled.
ISA 3000: No DHCP server enabled.
FTDv: The address pool on the inside
interface is 192.168.45.46 -
192.168.45.254.
DHCP server for inside clients.
Yes, but indirectly. If you configure a static
IPv4 address for the outside interface,
DHCP server auto-configuration is
disabled.
Enabled on outside interface.DHCP auto-configuration for inside clients.
(Auto-configuration supplies clients with
addresses for WINS and DNS servers.)
Getting Started
27
Getting Started
Default Configuration Prior to Initial Setup

Other manuals for Cisco Firepower 1120

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Firepower 1120 and is the answer not in the manual?

Cisco Firepower 1120 Specifications

General IconGeneral
Processor cores12
Processor familyIntel
Built-in processorYes
Firewall throughput1500 Mbit/s
Wi-FiNo
IPSec VPN throughput1 Gbit/s
Maximum firewall connections200000
Maximum firewall connections per second75000
Supported network protocolsSMTP
Console portRJ-45
Connectivity technologyWired
Number of console ports1
SFP module slots quantity4
Ethernet LAN (RJ-45) ports8
SSD capacity200 GB
Storage media typeSSD
Form factor1U
Input current2 A
AC input voltage100-240 V
AC input frequency50 - 60 Hz
Power consumption (max)100 W
Operating altitude0 - 3000 m
Storage temperature (T-T)-25 - 70 °C
Operating temperature (T-T)0 - 40 °C
Operating relative humidity (H-H)10 - 90 %
Country of originMexico
Quantity per pack1 pc(s)
Harmonized System (HS) code85176990
Package depth1409.7 mm
Package width990.6 mm
Package height457.2 mm
Package weight5782.31 g
Weight and Dimensions IconWeight and Dimensions
Depth436.9 mm
Width268.7 mm
Height43.7 mm

Related product manuals