See the show inventory command in the Cisco Firepower Threat Defense Command Reference or the
Cisco ASA Series Command Reference to display a list of the PIDs for your Firepower 1100.
Note
Table 3: Firepower 1100 Series PIDs
DescriptionPID
Cisco Firepower 1120 NGFW applianceFPR1120-NGFW-K9
Cisco Firepower 1140 NGFW applianceFPR1140-NGFW-K9
Cisco Firepower 1150 NGFW applianceFPR1150-NGFW-K9
Cisco Firepower 1100 200-GB driveFPR1K-RM-SSD200
Cisco Firepower 1100 200-GB drive (spare)FPR1K-RM-SSD200=
Cisco Firepower 1100 cable-management bracketsFPR1K-CBL-MGMT
Cisco Firepower 1100 cable-management brackets
(spare)
FPR1K-CBL-MGMT=
Cisco Firepower 1100 accessory kitFPR1K-RM-ACY-KIT
Cisco Firepower 1100 rack-mount brackets (spare)FPR1K-RM-BRKT=
Cisco Firepower 1100 FIPS kitFPR1K-RM-FIPS-KIT
Power Cord Specifications
Each power supply has a separate power cord. Standard power cords or jumper power cords are available for
connection to the security appliance. The jumper power cords for use in racks are available as an optional
alternative to the standard power cords.
If you do not order the optional power cord with the system, you are responsible for selecting the appropriate
power cord for the product. Using a incompatible power cord with this product may result in electrical safety
hazard. Orders delivered to Argentina, Brazil, and Japan must have the appropriate power cord ordered with
the system.
Only the approved power cords or jumper power cords provided with the chassis are supported.
Note
The following power cords are supported.
Cisco Firepower 1100 Series Hardware Installation Guide
12
Overview
Power Cord Specifications