Although non-Cisco SFPs are allowed, we do not recommend using them because they have not been tested
and validated by Cisco. Cisco TAC may refuse support for any interoperability problems that result from
using an untested third-party SFP transceiver. See Supported SFP/SFP+ Transceivers, on page 26 for a list
of supported Cisco transceivers.
Caution
Use appropriate ESD procedures when inserting the transceiver. Avoid touching the contacts at the rear, and
keep the contacts and ports free of dust and dirt. Store unused SPFs in their ESD packaging.
Note
Step 6 Attach the power cable to the Firepower 2100 and connect it to an electrical outlet.
Step 7 Press the power switch on the rear panel.
Step 8 Check the PWR LED on the front panel. Solid green indicates that the Firepower 2100 is powered on.
Step 9 Check the SYS LED on the front panel. Solid green indicates that the system has passed power-on diagnostics.
When you toggle the power switch from ON to OFF, it takes several seconds for the system to power off.
Do not remove the power cable until the PWR LED is completely off. After removing power from the chassis
by unplugging the power cord, wait at least 10 seconds before turning power back ON. See Rear Panel, on
page 14 for more information on the power switch.
Note
Step 10 See the Cisco ASA for Firepower 2100 Series Getting Started Guide for more information about configuring the
Firepower 2100.
Cisco Firepower 2100 Series Hardware Installation Guide
65
Mount and Connect
Connect Cables, Turn on Power, and Verify Connectivity for Cisco ASA
To Next Page
Loading...
Need help?
General
