Cisco Firepower 2130 Installation & Maintenance

Figure 8: Connect the Tie Wrap
Hexagonal hole2Tie wrap1
Step 3 Secure the clamp:
a) Plug in the power supply power cord and wrap the clamp around the over mold portion of the power cord.
b) Squeeze the clamp tabs together so that the annular teeth engage with the mate on the clamp.
c) Make sure the clamp fits snugly into the over mold.
d) Adjust the clamp position on the tie wrap so that the clamp is tight against the front of the over mold and the power
cord cannot be removed by lightly pulling on it.
Figure 9: Clamp on Over Mold of Power Cord
Power cord over mold2Power cord1
Direction to squeeze the clamp tabs4Tie clamp annular teeth3
Installation, Maintenance, and Upgrade
17
Installation, Maintenance, and Upgrade
Secure the Power Cord on the Power Supply Module

Cisco Firepower 2130 Specifications

General

Form Factor	1 RU
Firewall Throughput (Application Visibility and Control AVC)	4 Gbps
RAM	16 GB
Storage	120 GB SSD
Interfaces	8 x 1GE
Power Supply	Dual, Hot-swappable