Getting Started
The following topics explain how to get started configuring the Firepower Threat Defense (FTD) .
• Is This Guide for You?, on page 1
• New Features in FDM/FTD Version 7.1.0, on page 2
• Logging Into the System, on page 7
• Setting Up the System, on page 11
• Configuration Basics, on page 32
Is This Guide for You?
This guide explains how to configure Firepower Threat Defense using the Firepower Device Manager (FDM)
web-based configuration interface included on the Firepower Threat Defense devices.
The FDM lets you configure the basic features of the software that are most commonly used for small or
mid-size networks. It is especially designed for networks that include a single device or just a few, where you
do not want to use a high-powered multiple-device manager to control a large network containing many
Firepower Threat Defense devices.
If you are managing large numbers of devices, or if you want to use the more complex features and
configurations that Firepower Threat Defense allows, use the Firepower Management Center (FMC) to
configure your devices instead of the integrated FDM.
You can use the FDM on the following devices.
Table 1: FDM Supported Models
Minimum FTD Software VersionDevice Model
6.4Firepower 1010, 1120, 1140
6.5Firepower 1150
6.2.1Firepower 2110, 2120, 2130, 2140
7.1Secure Firewall 3110, 3120, 3130, 3140
6.5Firepower 4110, 4115, 4120, 4125, 4140, 4145, 4150
6.6Firepower 4112
Getting Started
1
To Next Page
Need help?
General
