27
IC (Industry Canada) Notice
Notice: The Industry Canada (formerly Canadian
Department of Communications) label identi es certi ed
equipment. This certi cation means that the equipment
meets certain telecommunications network protective,
operational, and safety requirements. The department
does not guarantee the equipment will operate to the
user’s satisfaction.
Before installing this equipment, users should ensure
that it is permissible to be connected to the facilities of
the local telecommunications company. The equipment
must also be installed using an acceptable method of
connection. In some cases, the company’s inside wiring
associated with a single-line individual service may be
extended by means of a certi ed connector assembly
(telephone extension cord). The customer should be
aware that compliance with the above conditions may
not prevent degradation of service in some situations.
Repairs to certi ed equipment should be made by an
authorized Canadian maintenance facility designated
by the supplier. Any repairs or alterations made by
the user may give the telecommunications company
cause to request the user to disconnect the equipment.
Users should ensure for their own protection that the
electrical ground connections of the power utility,
telephone lines and internal metallic water pipe
system, if present, are connected together. This
precaution may be particularly important in rural areas.
CAUTION: Users should not attempt to
make such connections themselves, but should
contact the appropriate electric inspection
authority, or electrician, as appropriate.
This device complies with Industry Canada licence-
exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not
cause interference, and (2) this device must accept
any interference, including interference that may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR
d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux
deux conditions suivantes : (1) l'appareil ne doit pas
produire de brouillage, et (2) l'utilisateur de
l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
Caution:
The device for the band 5150-5250 MHz is only for indoor
usage to r
educe potential for harmful interference to
co-channel mobile satellite systems.
High power r
a
dars are allocated as primary
users (meaning they have priority) of
5250-5350 MHz and 5650-5850 MHz and these
radars could cause interference and/or damage to
LE-LAN devices.
RF Exposure Statements
Note: This transmitter must not be co-located or
operated in conjunction with any other antenna or
transmitter. This equipment should be installed and
operated with a minimum distance of 7.9 inches (20 cm)
between the radiator and your body.
The availability of some specific channels and/or
operational frequency bands are country dependent
and are rmware programmed at the factory to match
the intended destination. The rmware setting is not
accessible by the end user.
US
This system has been evaluated for RF exposure for
humans in reference to ANSI C 95.1 (American National
Standards Institute) limits. The evaluation was based on
evaluation per ANI C 95.1 and FCC OET Bulletin 65C
rev 01.01. The minimum separation distance from the
antenna to general bystander is 7.9 inches (20 cm) to
maintain compliance.
Canada
This system has been evaluated for RF exposure for
humans in reference to Canada Health Code 6 (2009)
limits. The evaluation was based on evaluation per RSS-
102 Rev 4. The minimum separation distance from the
antenna to general bystander is 7.9 inches (20 cm) to
maintain compliance.
Note: The IPV5050 has disabled the 5600-5650M
band by S/W to avoid 5600-5650M band for IC
certi cation.
EU
This system has been evaluated for RF exposure
for humans in reference to the ICNIRP (International
Commission on Non-Ionizing Radiation Protection)
limits. The evaluation was based on the EN 50385
Product Standard to Demonstrate Compliance of
Radio Base Stations and Fixed Terminals for Wireless
Telecommunications Systems with basic restrictions or
reference levels related to Human Exposure to Radio
Frequency Electromagnetic Fields from 300 MHz to 40
GHz. The minimum separation distance from the antenna
to general bystander is 20 cm (7.9 inches).
Australia
This system has been evaluated for RF exposure for
humans as referenced in the Australian Radiation
Protection standard and has been evaluated to the
ICNIRP (International Commission on Non-Ionizing
Radiation Protection) limits. The minimum separation
distance from the antenna to general bystander is 20 cm
(7.9 inches).
20090317 FCC DSL_Dom and Intl
To Next Page
Loading...
Need help?
General
