Reset:
There are two ways to reset the Linksys E900 to its factory defaults. Either press or
hold the Reset button for approximately five seconds, or restore the defaults from the
Administration > Factory Defaults page on the router's web-based setup page.
TABLE OF CONTENTS
HARDWARE INFORMATION
1. What is E900?
2. What is the default IP Address, Username and Password to login to the
E900’s web-based setup page?
3. How do I reset the E900 to factory defaults?
4. What is the Warranty period of the E900?
5. How do I reboot the E900?
6. Does E900 support remote management?
SECURITY SUPPORTED
1. What is the default SSID broadcast of E900?
2. How many security modes are supported in E900?
3. Does E900 allow VPN tunnels using IPSec, L2TP, or PPTP protocols to
pass through the router?
4. Does E900 support SPI firewall?
5. How does Web Filter work?
FIRMWARE UPGRADE METHOD
1. How do I upgrade the Firmware of the E900?
SPECIAL FEATURES
1. What DDNS providers does the E900 support?
2. How many connection types does the E900 support?
3. Does E900 support AP Isolation?
4. Does E900 support wireless and Internet Access Priority QOS?
5. Does E900 support transmission of the log information to a log server?
6. Does E900 lose the settings you have customized when its firmware has
To Next Page
Loading...
Need help?
General
