8
Chapter 4: Connecting the Compact Wireless-G Internet Video Camera for Setup
Overview
Compact Wireless-G Internet Video Camera
Chapter 4: Connecting the Compact Wireless-G Internet
Video Camera for Setup
Overview
Before you set up the Camera, connect it to your wired network.
If you need to move the Camera from a wired network to a wireless network, or vice versa, go to this section,
“Moving the Camera to a Different Network.”
Connection to a Wired Network for Setup
1. Connect the Ethernet network cable to your router, switch, or computer.
2. Connect the other end of the cable to the Ethernet port on the Camera.
3. Connect the power adapter to the Power port on the Camera.
4. Plug the power adapter into an electrical outlet.
The Camera’s power LED flashes while the Camera is initializing. The Camera is ready for use when the LED is
solidly lit.
Proceed to “Chapter 5: Setting up and Mounting the Compact Wireless-G Internet Video Camera.”
NOTE: You MUST connect the Camera to a PC,
router, or switch using the Ethernet network
cable BEFORE powering on the Camera.
Otherwise, the Camera will not function.
Figure 4-2: Connect the Power Adapter
Figure 4-1: Connect the Ethernet Network Cable
To Next Page
Loading...
Need help?
General
