Procedure
Step 1
Identify and attach the sliding edge for the 2/4 post rack.
Step 2
Attach the sliding rail and L bracket to the left and right of the chassis using the screws (48-0471-01 and 48-2406-01) and
tighten them to a torque value of 0.65 N-m (5.9 in-lbs) for 48-0471-01 screws and torque value of 1.5 N-m (13.25 in-lbs)
for 48-2406-01 screws.
Figure 5: Sliding Edge
Sliding edge1
Screws for sliding edge (part number - 48-0471-01)2
The edge always need to be facing bottom side on both the sides.3
11
To Next Page
Loading...
