What to do if the test set indicates errors during the loopback test on Cisco NCS 2000?
If your test set indicates errors during the loopback test on your Cisco Network Hardware, proceed to complete the 'Test the MXP, TXP, XP or ADM-10G Card' procedure.
What to do if the test set indicates errors during terminal loopback on Cisco NCS 2000 Network Hardware?
If the test set indicates errors during terminal loopback on your Cisco Network Hardware, complete the 'Test the MXP, TXP, XP, or ADM-10G Card' procedure.
What to do if the test set indicates no errors during the loopback test on Cisco NCS 2000?
If the test set shows no errors during the loopback test on your Cisco Network Hardware, no further testing is necessary with the facility loopback.
What to do if the test set indicates no errors during terminal loopback on Cisco Network Hardware?
If the test set indicates no errors during terminal loopback on your Cisco Network Hardware, then no further testing is necessary on the loopback circuit.
General| Typical Capacity | Varies by configuration |
|---|---|
| Product Series | NCS 2000 |
| Product Family | Network Convergence System |
| Product Category | Optical Transport |
| Slot Count | Varies by model |
| Wavelengths | C-band and L-band |
| Line Rate Support | 100G, 200G, 400G |
| Client Interface | 10GE, 40GE, 100GE |
| Client Interfaces | Ethernet, OTN |
| Management | Cisco Prime |
| Redundancy | Power supply, fan |
| Power Supply | AC or DC |
| Power Consumption | Varies by configuration |
| Operating Temperature | 0°C to 45°C (32°F to 113°F) |
| Storage Temperature | -40°C to 70°C (-40°F to 158°F) |
| Relative Humidity | 5% to 95% non-condensing |
| Dimensions | Varies by model |
| Weight | Varies by model |
| Compliance | NEBS, ETSI |
To Next Page
