Cisco NCS 2000 series Troubleshoot Manual

Clear the EQPT-DEGRADE Condition
SUMMARY STEPS
1. Remove and reinsert the card where the EQPT-DEGRADE condition is raised. If the reinsertion does not
clear the alarm, replace the card. Complete the Physically Replace a Card, on page 453 procedure to replace
the card.
DETAILED STEPS
Remove and reinsert the card where the EQPT-DEGRADE condition is raised. If the reinsertion does not clear the alarm,
replace the card. Complete the Physically Replace a Card, on page 453 procedure to replace the card.
If the condition does not clear, log into the Technical Support Website at http://www.cisco.com/c/en/us/support/index.html
for more information or call Cisco TAC (1 800 553-2447).
EQPT-DIAG
Default Severity: Critical (CR), Service-Affecting (SA)
Logical Object: EQPT
An Equipment-Diagnostic Failure alarm indicates that a software or hardware failure has occurred on the
reporting card. This alarm can be raised against a traffic card or a cross-connect card.
Clear the EQPT-DIAG Alarm
SUMMARY STEPS
1. If traffic is active on the alarmed card, you could need to switch traffic away from it. Refer to the Protection
Switching, Lock Initiation, and Clearing, on page 443 section for procedures.
2. Complete the Remove and Reinsert (Reseat) Any Card , on page 452 procedure for the alarmed card
3. If the alarm does not clear, complete the Physically Replace a Card, on page 453 procedure if it is raised
against a traffic card, or complete the Generic Signal and Circuit Procedures, on page 454 procedure if the
alarm is raised against the cross-connect card.
DETAILED STEPS
Step 1 If traffic is active on the alarmed card, you could need to switch traffic away from it. Refer to the Protection Switching,
Lock Initiation, and Clearing, on page 443 section for procedures.
Step 2 Complete the Remove and Reinsert (Reseat) Any Card , on page 452 procedure for the alarmed card
Step 3 If the alarm does not clear, complete the Physically Replace a Card, on page 453 procedure if it is raised against a traffic
card, or complete the Generic Signal and Circuit Procedures, on page 454 procedure if the alarm is raised against the
cross-connect card.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
182
Alarm Troubleshooting
Clear the EQPT-DEGRADE Condition

Cisco NCS 2000 series Specifications

General

Brand	Cisco
Model	NCS 2000 series
Category	Network Hardware
Language	English