Cisco NCS 2000 series Troubleshoot Manual

LPBKTERMINAL (GE)
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: GE
A Loopback Terminal condition for a GE port occurs when a software terminal (inward) loopback is active
for an MXP_MR_2.5G, MXPP_MR_2.5G, TXP_MR_2.5G, and TXPP_MR_2.5G card client PPM (SFP)
provisioned at the ONE_GE port rate. For the TXP_MR_10E and TXP_MR_10G cards, this condition occurs
when there is a facility loopback on a client PPM (SFP) provisioned at the TEN_GE port rate.
For information about troubleshooting these circuits with loopbacks, refer to the Troubleshooting MXP, TXP,
XP, or ADM-10G Circuit Paths With Loopbacks, on page 7 section.
Clear the LPBKTERMINAL (GE) Condition
SUMMARY STEPS
1. Complete the Clear an MXP, TXP, GE-XP, 10GE-XP, and ADM-10G Card Loopback Circuit, on page
455 procedure.
DETAILED STEPS
Complete the Clear an MXP, TXP, GE-XP, 10GE-XP, and ADM-10G Card Loopback Circuit, on page 455 procedure.
If the condition does not clear, log into the Technical Support Website at http://www.cisco.com/c/en/us/support/index.html
for more information or call Cisco TAC (1 800 553-2447).
LPBKTERMINAL (ISC)
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: ISC
A Loopback Terminal condition for an ISC port occurs when a software terminal (inward) loopback is active
for a TXPP_MR_2.5G or TXP_MR_2.5G client PPM (SFP) provisioned at the ISC port rate.
For information about troubleshooting these circuits with loopbacks, refer to the Troubleshooting MXP, TXP,
XP, or ADM-10G Circuit Paths With Loopbacks, on page 7 section.
Clear the LPBKTERMINAL (ISC) Condition
SUMMARY STEPS
1. Complete the Clear an MXP, TXP, GE-XP, 10GE-XP, and ADM-10G Card Loopback Circuit, on page
455 procedure.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
297
Alarm Troubleshooting
LPBKTERMINAL (GE)

Cisco NCS 2000 series Specifications

General

Brand	Cisco
Model	NCS 2000 series
Category	Network Hardware
Language	English