CARLOSS (FC)
Default Severity: Major (MJ), Service-Affecting (SA)
Logical Object: FC
The Carrier Loss for Fibre Channel (FC) alarm occurs on the client port of a TXP_MR_10G, TXP_MR_10E,
TXP_MR_10E_C, TXP_MR_10E_L, TXP_MR_2.5G, TXPP_MR_2.5G, MXP_MR_2.5G, MXPP_MR_2.5G,
MXP_MR_10DME_C, MXP_MR_10DME_L, supporting 1-Gb Fibre Channel (FC1G), 2-Gb FC (FC2G),
or 10Gb Fiber Channel (10G Fiber Channel) traffic. The loss can be due to a misconfiguration, fiber cut, or
client equipment problem.
Clear the CARLOSS (FC) Alarm
SUMMARY STEPS
1. Complete the Clear the CARLOSS (GE) Alarm, on page 149 procedure.
DETAILED STEPS
Complete the Clear the CARLOSS (GE) Alarm, on page 149 procedure.
If the alarm does not get cleared, you need to report a Service-Affecting (SA) problem. Log into the Technical Support
Website at http://www.cisco.com/c/en/us/support/index.html for more information or log into http://www.cisco.com/c/
en/us/support/web/tsd-cisco-worldwide-contacts.html to obtain a directory of toll-free Technical Support numbers for
your country.
CARLOSS (GE)
Default Severity: Major (MJ), Service-Affecting (SA)
Logical Object: GE
The Carrier Loss for Gigabit Ethernet (GE) alarm occurs on the client port of a TXP_MR_10G, TXP_MR_10E,
TXP_MR_10E_C, TXP_MR_10E_L, TXP_MR_2.5G, TXPP_MR_2.5G, MXP_MR_2.5G, MXPP_MR_2.5G,
MXP_MR_10DME_C, MXP_MR_10DME_L, GE-XP, 10GE-XP, or ADM-10G cards supporting 1-Gbps
or 10-Gbps traffic. The loss can be due to a misconfiguration, fiber cut, or client equipment problem.
Clear the CARLOSS (GE) Alarm
SUMMARY STEPS
1. Ensure that the GE client is correctly configured:
2. If there is no PPM (SFP) misprovisioning, check for a fiber cut. An LOS alarm would also be present. If
there is an alarm, complete the Clear the LOS (OCN/STMN) Alarm procedure located in Chapter 2, Alarm
Troubleshooting, of the Troubleshooting guide.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
149
Alarm Troubleshooting
CARLOSS (FC)
To Next Page
Loading...
Need help?
General
