TXP_MR_10G cards, this condition occurs when there is a facility loopback on a client PPM (SFP) provisioned
at the TEN_GE port rate.
For information about troubleshooting these circuits with loopbacks, refer to the Troubleshooting MXP, TXP,
XP, or ADM-10G Circuit Paths With Loopbacks, on page 7 section.
Clear the LPBKFACILITY (GE) Condition
SUMMARY STEPS
1. Complete the Clear an MXP, TXP, GE-XP, 10GE-XP, and ADM-10G Card Loopback Circuit, on page
455 procedure.
DETAILED STEPS
Complete the Clear an MXP, TXP, GE-XP, 10GE-XP, and ADM-10G Card Loopback Circuit, on page 455 procedure.
If the condition does not clear, log into the Technical Support Website at http://www.cisco.com/c/en/us/support/index.html
for more information or call Cisco TAC (1 800 553-2447).
LPBKFACILITY (ISC)
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: ISC
A Loopback Facility condition for an ISC port occurs when a software facility (line) loopback is active for a
TXPP_MR_2.5G or TXP_MR_2.5G client PPM (SFP) provisioned at the ISC port rate.
For information about troubleshooting these circuits with loopbacks, refer to the Troubleshooting MXP, TXP,
XP, or ADM-10G Circuit Paths With Loopbacks, on page 7 section.
Clear the LPBKFACILITY (ISC) Condition
SUMMARY STEPS
1. Complete the Clear an MXP, TXP, GE-XP, 10GE-XP, and ADM-10G Card Loopback Circuit, on page
455 procedure.
DETAILED STEPS
Complete the Clear an MXP, TXP, GE-XP, 10GE-XP, and ADM-10G Card Loopback Circuit, on page 455 procedure.
If the condition does not clear, log into the Technical Support Website at http://www.cisco.com/c/en/us/support/index.html
for more information or call Cisco TAC (1 800 553-2447).
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
294
Alarm Troubleshooting
Clear the LPBKFACILITY (GE) Condition
To Next Page
Loading...
Need help?
General
