Cisco NCS 2000 series Troubleshoot Manual

Resetting the active control card switches control to the standby control card. If the alarm clears when the node switches
to the standby control card, the user can assume that the previously active card is the cause of the alarm.
Step 9 If the control card reset does not clear the alarm, delete the problematic RS-DCC termination by completing the following
steps:
a) From card view, click View > Go to Previous View if you have not already done so.
b) Click the Provisioning > Comm Channels > RS-DCC tabs.
c) Highlight the problematic DCC termination.
d) Click Delete.
e) Click Yes in the Confirmation Dialog box.
Step 10 Recreate the RS-DCC termination. Refer to the Turn Up Network chapter in the Configuration guide for procedures.
Step 11 Verify that both ends of the DCC have been recreated at the optical ports.
If the condition does not clear, log into the Technical Support Website at http://www.cisco.com/c/en/us/support/
index.html for more information or call Cisco TAC (1 800 553-2447).
If the Technical Support technician tells you to reseat the card, complete the Remove and Reinsert (Reseat) Any Card
, on page 452 procedure. If the Technical Support technician tells you to remove the card and reinstall a new one, follow
the Physically Replace a Card, on page 453 procedure.
RS-TIM
Default Severity: Critical (CR), Service-Affecting (SA)
Logical Object: STMN
The Regenerator Section TIM alarm occurs when the expected J0 path trace string does not match the received
string.
If the alarm occurs on a port that has been operating with no alarms, the circuit path has changed or someone
entered a new incorrect value into the Current Transmit String field. Follow the procedure below to clear
either instance.
Clear the RS-TIM Alarm
SUMMARY STEPS
1. Complete the Clear the TIM Alarm, on page 415 procedure for the J0 byte.
DETAILED STEPS
Complete the Clear the TIM Alarm, on page 415 procedure for the J0 byte.
If the alarm does not get cleared, you need to report a Service-Affecting (SA) problem. Log into the Technical Support
Website at http://www.cisco.com/c/en/us/support/index.html for more information or log into http://www.cisco.com/c/
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
383
Alarm Troubleshooting
RS-TIM

Cisco NCS 2000 series Specifications

General

Brand	Cisco
Model	NCS 2000 series
Category	Network Hardware
Language	English