Cisco NCS 2000 series

Clear the ALS-DISABLED Condition
SUMMARY STEPS
1. In node view (single-shelf mode) or shelf view (multishelf mode), double-click the OPT-BST, or OPT-PRE,
OPT-AMP-C, or OMP-AMP-17-C card to display the card view.
2. Click the Maintenance > ALS tabs.
3. In the ALS Mode column, change the entry from Disabled to your required state.
DETAILED STEPS
Step 1 In node view (single-shelf mode) or shelf view (multishelf mode), double-click the OPT-BST, or OPT-PRE, OPT-AMP-C,
or OMP-AMP-17-C card to display the card view.
Step 2 Click the Maintenance > ALS tabs.
Step 3 In the ALS Mode column, change the entry from Disabled to your required state.
If the condition does not clear, log into the Technical Support Website at http://www.cisco.com/c/en/us/support/index.html
for more information or call Cisco TAC (1 800 553-2447).
AMPLI-INIT
Default Severity:Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: AOTS
The Amplifier Initialized condition occurs when an amplifier card (OPT-BST or OPT-PRE) is not able to
calculate gain. This condition typically accompanies the APC-DISABLED , on page 119 alarm.
Clear the AMPLI-INIT Condition
SUMMARY STEPS
1. Complete the Delete a Circuit, on page 454 procedure on the most recently created circuit.
2. Recreate this circuit using the procedures in the Configuration guide.
DETAILED STEPS
Step 1 Complete the Delete a Circuit, on page 454 procedure on the most recently created circuit.
Step 2 Recreate this circuit using the procedures in the Configuration guide.
If the condition does not clear, log into the Technical Support Website at http://www.cisco.com/c/en/us/support/index.html
for more information or call Cisco TAC (1 800 553-2447).
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
118
Alarm Troubleshooting
Clear the ALS-DISABLED Condition