Cisco NCS 2000 series Troubleshoot Manual

Clear the APC-DISABLED Alarm
SUMMARY STEPS
1. Complete the appropriate procedure to clear the main alarm:
2. If the condition does not clear, complete the Delete a Circuit procedure and then recreate it using
procedures in the Configuration guide.
DETAILED STEPS
Step 1 Complete the appropriate procedure to clear the main alarm:
• Clear the EQPT Alarm
• Clear the IMPROPRMVL Alarm
• Clear the MEA (EQPT) Alarm
Step 2 If the condition does not clear, complete the Delete a Circuit procedure and then recreate it using procedures in the
Configuration guide.
If the condition does not clear, log into the Technical Support Website at http://www.cisco.com/c/en/us/support/index.html
for more information or call Cisco TAC (1 800 553-2447).
APC-END
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: NE
The APC Terminated on Manual Request condition is raised when APC terminates after it is manually launched
from CTC or TL1. APC-END is an informational condition that is raised and cleared spontaneously by the
system and is not visible in the CTC Condition window. It is visible only by retrieving it in the Conditions or
History tabs.
APC-END is an informational condition and does not require troubleshooting.
Note
APC-OUT-OF-RANGE
Default Severity: Minor (MN), Non-Service-Affecting (NSA)
Logical Objects: AOTS, OCH, OMS, OTS
The APC-OUT-OF-RANGE condition is raised on amplifier cards OPT-PRE, OPT-PRE, OPT-AMP-17-C,
OPT-AMP-C, OPT-RAMP-C, and OPT-BST-E); and demultiplexer cards (32-DMX, 40-DMX-C, and
32-DMX-L) having a single variable optical attenuator (VOA) when the requested gain or attenuation setpoint
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
120
Alarm Troubleshooting
Clear the APC-DISABLED Alarm

Cisco NCS 2000 series Specifications

General

Brand	Cisco
Model	NCS 2000 series
Category	Network Hardware
Language	English