Cisco NCS 2000 series

Clear the ODUK-1-AIS-PM Condition
SUMMARY STEPS
1. Look for and clear the LOS (2R) alarm on the far-end client. This should clear the ODUK-1-AIS-PM
condition on the trunk.
DETAILED STEPS
Look for and clear the LOS (2R) alarm on the far-end client. This should clear the ODUK-1-AIS-PM condition on the
trunk.
If the condition does not clear, log into the Technical Support Website at http://www.cisco.com/c/en/us/support/index.html
for more information or call Cisco TAC (1 800 553-2447).
ODUK-2-AIS-PM
Default Severity: Not Reported (NR), Non-Service-Affecting (NSA)
Logical Object: TRUNK
The ODUK-2-AIS-PM is a secondary condition raised on MXP and ADM-10G cards trunk signals when they
experience an LOS (2R). Although the ODUK-2-AIS-PM is raised against the TRUNK object, it actually
refers to the client signals contained within the trunk.
Clear the ODUK-2-AIS-PM Condition
SUMMARY STEPS
1. Complete the Clear the ODUK-1-AIS-PM Condition, on page 315 procedure.
DETAILED STEPS
Complete the Clear the ODUK-1-AIS-PM Condition, on page 315 procedure.
If the condition does not clear, log into the Technical Support Website at http://www.cisco.com/c/en/us/support/index.html
for more information or call Cisco TAC (1 800 553-2447).
ODUK-3-AIS-PM
Default Severity: Not Reported (NR), Non-Service-Affecting (NSA)
Logical Object: TRUNK
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
315
Alarm Troubleshooting
Clear the ODUK-1-AIS-PM Condition