Cisco NCS 2000 series Troubleshoot Manual

If the condition does not clear, log into the Technical Support Website at http://www.cisco.com/c/en/us/support/index.html
for more information or call Cisco TAC (1 800 553-2447).
INHSWWKG
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: EQPT
The Inhibit Switch To Working Request on Equipment condition occurs on traffic cards when the ability to
switch to working has been disabled. If the card is part of a 1:1 or 1+1 protection scheme, traffic remains
locked onto the protect system. If the card is part of a 1:N protection scheme, traffic can be switched between
protect cards when the switch to working is disabled.
Clear the INHSWWKG Condition
SUMMARY STEPS
1. If the condition is raised against a 1+1 port, complete the Initiate a 1+1 Manual Switch Command, on
page 444 procedure.
2. If it is raised against a 1:1 card, complete the Initiate a 1:1 Card Switch Command, on page 445 procedure
to switch it back.
DETAILED STEPS
Step 1 If the condition is raised against a 1+1 port, complete the Initiate a 1+1 Manual Switch Command, on page 444 procedure.
Step 2 If it is raised against a 1:1 card, complete the Initiate a 1:1 Card Switch Command, on page 445 procedure to switch it
back.
If the condition does not clear, log into the Technical Support Website at http://www.cisco.com/c/en/us/support/index.html
for more information or call Cisco TAC (1 800 553-2447).
INCOMPATIBLE-SEND-PDIP
Default Severity: Minor (MN), Non-Service-Affecting (NSA)
Logical Object: SYSTEM
The Incompatible Software alarm is raised when CTC send PDI-P provisioning differs from the host node's
provisioning.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
238
Alarm Troubleshooting
INHSWWKG

Cisco NCS 2000 series Specifications

General

Brand	Cisco
Model	NCS 2000 series
Category	Network Hardware
Language	English