Cisco NCS 1001 - Page 13

The grounding extender must be assembled before installing NCS 1001 into the
rack.
Note
Figure 7: Grounding Extender
The counter sink surface must face outside as per the figure.
Grounding extender1
Extender screws (part number - 48-1142-01)2
Step 4
Install four post slider or two post slider as required.
a) Install Four Post Slider into EIA/ANSI Rack, on page 16
b) Install Two Post Slider into EIA/ANSI Rack, on page 22
Step 5
Insert the chassis onto the sliding rail assembled on the two or four post 19" or 23" rack.
13