During assembly of the unit, rest the sliding edge on the sliding rail groove on either side. Push the chassis gently
onto the rack until the faceplate makes in contact with the rack surface.
2
Slider fixing screws (part number - 48-101524-01).3
Step 6
As soon as the chassis is completely inserted, fasten the chassis with two screws (48-101524-01) on each side of the bracket
and tighten them to a torque value of 3.4 N-m (30 in-lbs).
The sliding rail must be used only during the first mounting process and it serves only to push the chassis into
the rack and not for sliding purpose. The chassis must be fixed with screws on the front side.
Caution
15
To Next Page
Loading...
