DescriptionMPO Cables
Multi-fiber patch cord with MPO-12 connectors. The
12 fibers have crossed fiber interconnections. There
are four variants: two, four, six, and eight meters.
• ONS-12MPO-XMPO-2=
• ONS-12MPO-XMPO-4=
• ONS-12MPO-XMPO-6=
• ONS-12MPO-XMPO-8=
The cable is used to interconnect the
NCS2K-MF-DEG-5-CV and the
NCS2K-MF-UPG-4-CV passive modules with the
NCS2K-MF-MPO-8LC adapter.
ONS-12MPO-XMPO-x
Multi-fiber patch cord with MPO-24 connectors that
has only 16 fibers connected. Fibers 1, 2, 11, 12, 13,
14, 23, and 24 are not connected. There are four
variants: two, four, six, and eight meters.
• ONS-16MPO-MPO-2=
• ONS-16MPO-MPO-4=
• ONS-16MPO-MPO-6=
• ONS-16MPO-MPO-8=
The cable is used for interconnections inside the
ROADM with MPO-24 standard. The patch cord can
be used for interconnections between SMR20 FS and
NCS2K-MF-M16LC-CV, or NCS2K-MF-2MPO-ADP
or NCS2K-PPMESH8-5AD. The patch cord can also
be used for interconnections between
NCS2K-16-AD-CCOFS and
NCS2K-MF-M16LC-CV.
ONS-16MPO-MPO-x
Safety Information
Before you install, operate, or service the passive optical modules, you must read the Regulatory Compliance
and Safety Information for Cisco NCS 2000 Series document for important safety information and warning
translations.
The passive optical modules are compliant with the GR 1089, UL60950 /CSA 22.2 No. 60950-00, and IEC
60950 standards.
Laser Radiation Emission Restrictions
The Class 1M Laser safety and warning label affixed to the passive optical modules indicate that the product
should never be used or installed in an optical network with emissions higher than Class 1M.
Class 1M laser radiation when open. Do not view directly with optical instruments. Statement 281
Warning
Installing the Cisco NCS 2000 Series Passive Optical Modules
4
Installing the Cisco NCS 2000 Series Passive Optical Modules
Safety Information
To Next Page
Loading...
Need help?
General
