Cisco Nexus 2232PP User Manual

Flow-control status: rx 0x0, tx 0x0, rx_mask 0x0
cos qos-group rx pause tx pause masked rx pause
-------+-----------+---------+---------+---------------
0 0 xon xon xon
1 0 xon xon xon
2 0 xon xon xon
3 0 xon xon xon
4 0 xon xon xon
5 2 xon xon xon
6 2 xon xon xon
7 n/a xon xon xon
DSCP to Queue mapping on FEX
----+--+-----+-------+--+---
FEX TCAM programmed successfully
queue DSCPs
----- -----
02 0-39,
04 40-63,
03 **EMPTY**
05 **EMPTY**
slot 10
=======
slot 11
=======
Interface is not in this module.
slot 15
=======
Interface is not in this module.
slot 16
=======
Interface is not in this module.
slot 17
=======
Interface is not in this module.
slot 18
=======
Interface is not in this module.
•
ISSU Behavior
In Cisco NX-OS Release 6.2(2) and later releases, FEX queuing is disabled by default on all existing
FEXs after an in-service software upgrade (ISSU). FEX queuing is enabled upon flapping the FEX. You
can reload the FEX to enable queuing on any FEX after an ISSU. A message is displayed in the output
of the show queuing interface interface command for the FEX host interface after an ISSU.
switch# show queuing interface ethernet 133/1/32 module 9
Ethernet133/1/32 queuing information:
Input buffer allocation:
Qos-group: ctrl
frh: 0
drop-type: drop
cos: 7
xon xoff buffer-size
---------+---------+-----------
Cisco Nexus 2000 Series NX-OS Fabric Extender Software Configuration Guide for Cisco Nexus 7000 Series
Switches, Release 5.2
16
Overview
FEX Queuing Support

Cisco Nexus 2232PP Specifications

General

Brand	Cisco
Model	Nexus 2232PP
Category	Extender
Language	English