Cisco Linksys RE1000 - User Manual

Linksys E3000
High Performance Wireless-N Router
Linksys RE1000
Wireless-N Extender
User Guide

Summary

Chapter 2: Advanced Configuration

Accessing the Browser-Based Utility

Explains how to access the Linksys RE1000 Extender's browser-based utility via IP address.

Using the Browser-Based Utility Interface

Guides users on navigating the browser-based utility using top-level and lower-level tabs.

Setup > Basic Setup

Static IP Configuration

Configures the Extender's IP address settings for a fixed IP connection to the upstream access point.

Wireless > Site Survey

Wireless > Basic Wireless Settings

Wi-Fi Protected Setup for Client Devices

WPS Button Setup (Client Mode)

Details using the WPS button on the Extender and router for automatic setup.

Enter Extender PIN on Router (Client)

Wi-Fi Protected Setup for AP Mode

WPS Button Setup (AP Mode)

Details using the WPS button on the client device and Extender for automatic setup.

Enter Client Device PIN on Extender (AP)

Wireless > Wireless Security

Wireless > QoS

Administration > Management

Device Access Management

Diagnostic Tests

Administration > Factory Defaults

Administration > Firmware Upgrade

Status > Device Information

Status > WLAN Statistics

Cisco Linksys RE1000 Specifications

General

Wireless Standard	802.11n
Wireless Speed	Up to 300 Mbps
Frequency Band	2.4 GHz
Ethernet Ports	1 x 10/100 Mbps
Security Features	WEP, WPA, WPA2
Antennas	2 internal
Operating Humidity	10% to 85% Non-condensing
Storage Humidity	5% to 90% Non-condensing
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-20°C to 70°C (-4°F to 158°F)