Cisco Linksys RE1000 User Manual

13
Wireless-N Extender
Linksys RE1000 Chapter 2: Advanced Configuration
Status > Device Information
The Device Information screen displays information about
the router and its current settings.
Status > Router
Device Information
Firmware Version The version number of the router’s
current firmware is displayed.
Firmware Verification The unique identifier of the
firmware is displayed.
Current Time The local time is displayed.
Internet MAC Address The router’s MAC address, as seen
from the Internet, is displayed.
Device Name The Device Name is the NetBIOS name
of the router. The default is Cisco followed by the last 5
digits of the router’s serial number, which is found on the
bottom of the router. If you used the setup software for
installation, then the Device Name is the name of your
wireless network (up to 15 characters).
Host Name The Host Name of the router is displayed.
Domain Name The Domain Name of the router is
displayed.
Internet Connection
This section shows the current network information. The
information varies depending on the Internet connection
type selected on the Setup > Basic Setup screen.
For a DHCP connection, select Release IP Address or
Renew IP Address as appropriate to release or renew
a DHCP lease. For a PPPoE or similar connection, select
Connect or Disconnect as appropriate to connect to or
disconnect from the Internet.
Click Refresh to update the on-screen information.
Status > Ethernet Statistics
The Ethernet Statistics screen displays information about
the local network.
Status > Local Network
Ethernet Statistics
Ethernet port status
The Status of the Extender’s local Ethernet port is
displayed.
Packet Sent (TX)
The number of packets transmitted is displayed.
Packets Received (RX)
The number of packets received is displayed.
Packets Dropped (TX)
The number of packets dropped on the transmit direction
is displayed.
Packets Dropped (RX)
The number of packets dropped on the receive direction
is displayed.
Collisions
The number of collisions occurring on the wire is displayed
Errors
The number of errors is displayed.
Ethernet Port Lights
Status > Ethernet Port light
On/Off
To allow the lights on the Extender’s Ethernet port to light
up, keep the default, On.

Cisco Linksys RE1000 Specifications

General

Wireless Standard	802.11n
Wireless Speed	Up to 300 Mbps
Frequency Band	2.4 GHz
Ethernet Ports	1 x 10/100 Mbps
Security Features	WEP, WPA, WPA2
Antennas	2 internal
Operating Humidity	10% to 85% Non-condensing
Storage Humidity	5% to 90% Non-condensing
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-20°C to 70°C (-4°F to 158°F)