14
Wireless-N Extender
Linksys RE1000 Chapter 2: Advanced Configuration
Wired Clients Table
Status > Wired Clients table
The name, MAC address and Hop number information on
the wired connected clients, is displayed.
Status > WLAN Statistics
The WLAN Statistics screen displays information about
your wireless network.
Status > Wireless Network
Wireless Interface MAC Address
The MAC address of the Extender wireless interface as
seen from the upstream AP, is displayed.
Upstream AP MAC Address
The MAC address of the Upstream AP connected is
displayed.
Network Name (SSID)
The name of the wireless network, also called the SSID, is
displayed.
Mode
The wireless mode used by the network is displayed.
Channel Width
The radio channel width used by Wireless-N devices is
displayed.
Channel
The Extender’s operating radio channel is displayed.
Wi-Fi Protected Setup
The Extender’s Wi-Fi Protected Setup is displayed.
Security
The wireless security method used by the wireless network
is displayed.
Signal Strength of the Upstream AP
The wireless security method used by the wireless network
is displayed.
Signal Quality of the Upstream AP:
The wireless security method used by the wireless network
is displayed.
Status
The status of the Extender wireless interface as seen
from the Upstream AP: Associated, Down, Association in
progress, Not configured, is displayed.
Uplink uptime
The duration that the Extender has been associated with
the AP is displayed in seconds.
Packet Count
The number of transmitted, received, dropped and in
error packets is displayed.
Packet Dropped
The number of packet dropped on the Upstream AP and
on the Client sides, is displayed.
Wireless Clients Table
Status > Wireless Client Table
The name, MAC address and Hop number information on
the wireless connected clients, is displayed.
To Next Page
Loading...
Need help?
General
