Cisco Nexus 5600 Series - show ipv6 mroute

Show Commands
show ipv6 mroute
MCR-97
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
show ipv6 mroute
To display information about IPv6 multicast routes, use the show ipv6 mroute command.
show ipv6 mroute {group | {source group} | {group [source]}} [summary [software-forwarded]]
[vrf {vrf-name | all}]
Syntax Description
Defaults None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command requires the Enterprise Services license.
Examples This example shows how to display information about multicast routes:
switch(config)# show ipv6 mroute
IPv6 Multicast Routing Table for VRF "default"
(*, ff30::/32), uptime: 1d02h, pim6 ipv6
Incoming interface: Null, RPF nbr: 0::
Outgoing interface list: (count: 0)
switch(config)#
group Group address for route.
source Source address for route.
summary (Optional) Displays route counts and packet rates.
software-
forwarded
(Optional) Displays software-switched route counts only.
vrf (Optional) Applies to a virtual routing and forwarding (VRF) instance.
vrf-name VRF name. The name can be a maximum of 32 alphanumeric characters and is case
sensitive.
all Specifies all VRFs.
Release Modification
5.0(3)N1(1) This command was introduced.