Cisco Nexus 5600 Series - Page 103

Show Commands
show ipv6 mroute summary
MCR-99
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
show ipv6 mroute summary
To display summary information about IPv6 multicast routes, use the show ipv6 mroute summary
command.
show ipv6 mroute summary [count | software-forwarded]] [vrf {vrf-name | all}]
show ipv6 mroute {group] summary [software-forwarded] [vrf {vrf-name | all}]
Syntax Description
Defaults None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command requires the Enterprise Services license.
Examples This example shows how to display summary information about multicast routes:
switch(config)# show ipv6 mroute summary
IPv6 Multicast Routing Table for VRF "default"
Total number of routes: 1
Total number of (*,G) routes: 0
Total number of (S,G) routes: 0
Total number of (*,G-prefix) routes: 1
Group count: 0, rough average sources per group: 0.0
count (Optional) Displays only route counts.
software-
forwarded
(Optional) Displays software-switched route counts only.
vrf (Optional) Applies to a virtual routing and forwarding (VRF) instance.
vrf-name VRF name. The name can be a maximum of 32 alphanumeric characters and is case
sensitive.
all Specifies all VRFs.
group Specifies a group address for a route.
Release Modification
5.0(3)N1(1) This command was introduced.