Show Commands
show ipv6 pim statistics
MCR-113
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
show ipv6 pim statistics
To display information about the packet counter statistics for IPv6 Protocol Independent Multicast
(PIM6), use the show ipv6 pim statistics command.
show ipv6 pim statistics [vrf {vrf-name | all}]
Syntax Description
Defaults None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command requires the Enterprise Services license.
Examples This example shows how to display information about PIM6 statistics:
switch(config)# show ipv6 pim statistics
PIM6 Global Counter Statistics for VRF:default, last reset: never
Register processing (sent/received):
Registers: 0/0, Null registers: 0/0, Register-Stops: 0/0
Registers received and not RP: 0
Registers received for SSM/Bidir groups: 0/0
BSR processing (sent/received):
Bootstraps: 0/0, Candidate-RPs: 0/0
BSs from non-neighbors: 0, BSs from border interfaces: 0
BS length errors: 0, BSs which RPF failed: 0
BSs received but not listen configured: 0
Cand-RPs from border interfaces: 0
Cand-RPs received but not listen configured: 0
Auto-RP processing (sent/received):
Auto-RP Announces: 0/0, Auto-RP Discoveries: 0/0
Auto-RP RPF failed: 0, Auto-RP from border interfaces: 0
vrf (Optional) Applies to a virtual routing and forwarding (VRF) instance.
vrf-name VRF name. The name can be a maximum of 32 alphanumeric characters and is case
sensitive.
all Specifies all VRFs.
Release Modification
5.0(3)N1(1) This command was introduced.
To Next Page
Loading...
