Cisco Nexus 5600 Series - show routing multicast

Show Commands
show routing multicast
MCR-124
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
show routing multicast
To display information about IPv4 multicast routes, use the show routing multicast command.
show routing [ip | ipv4] multicast [vrf {vrf-name | all | default | management}]
{{source group} | {group [source]}}
Syntax Description
Command Default None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command requires the LAN Base Services license.
Examples This example shows how to display information about IPv4 multicast routes:
switch(config)# show routing multicast
IP Multicast Routing Table for VRF "default"
(*, 232.0.0.0/8), uptime: 05:11:19, pim ip
Incoming interface: Null, RPF nbr: 0.0.0.0
Outgoing interface list: (count: 0)
ip (Optional) Specifies IPv4 routes.
ipv4 (Optional) Specifies IPv4 routes.
vrf (Optional) Applies to a virtual routing and forwarding (VRF) instance.
vrf-name VRF name. The name can be a maximum of 32 alphanumeric characters and is case
sensitive.
all Specifies all VRFs.
default Specifies the default VRF.
management Specifies the management VRF.
source Source address for routes.
group Group address for routes.
Release Modification
5.0(3)N1(1) This command was introduced.